[. . . ] Michigan Drive, Tongwell, Milton Keynes, Bucks MK15 8JD, ENGLAND 2 SAFETY INSTRUCTIONS ENA002-2 WARNING: When using battery operated tools basic safety precautions, including the following, should be followed to reduce the risk of fire, leaking batteries and personal injury: Read these instructions before operating this product and save these instructions. For safe operations: 1. When not in use, tools and batteries should be stored separately in a dry, high or locked up place, out of reach of children. Ensure that battery terminals cannot be shorted by other metal parts such as screws, nails, etc. It will do the job better and safer at the rate for which it was intended. [. . . ] Keep all parts of the body away from the saw chain when the motor is operating. Before you start the saw, make sure the saw chain is not contacting anything. Switch off the chain saw immediately if you notice anything abnormal in operation. Carefully inspect the chain saw if you drop or strike it against something hard. 13. When not in use, chain saws should be stored in a dry, and high or locked-up place -- out of reach of children. Also use safety footwear; snug fitting clothing; protective gloves; and head protection. Before making a cut, remove dirt, stones, loose bark, nails, staples and wire from the tree. Secure the workpiece so that it will not move suddenly during operation. To prevent the saw chain from being pinched in the cut, support the workpiece near the cut using blocks or the like. SAVE THESE INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CARTRIDGE 1. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Always cover the battery terminals with the battery cover when the battery cartridge is not used. 7. ENC004-1 (1) Do not touch the terminals with any conductive material. (2) Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. 3. 4. 5. 8. 6. SAVE THESE INSTRUCTIONS Tips for maintaining maximum battery life 4 1. Charge the battery cartridge before completely discharged. Always stop tool operation and charge the battery cartridge when you notice less tool power. Overcharging shortens the battery service life. 3. Charge the battery cartridge with room temperature at 10°C - 40°C (50°F - 104°F). [. . . ] 2 - 3 mm, slightly loosen the hex socket head bolt which secures the guide bar. Please have your saw chain sharpened at a Makita Authorized Service Center or replace with a new one if your saw chain does not cut correctly. 001750 Cleaning guide bar Chips and sawdust will build up in the guide bar groove, clogging it and impairing oil flow. Always clean out the chips and sawdust when sharpening or replacing the saw chain. 2 1 1. Remove any chips and sawdust from the tool after removing the chain cover. [. . . ]